HD64F2357VF13 Datasheet, PDF (90/1049 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

3.3 Operating Mode Descriptions
3.3.1 Mode 1
Mode 1 is not supported in this LSI, and must not be set.
3.3.2 Mode 2 (H8S/2398 F-ZTAT Only)
This is a flash memory boot mode. For details, see section 19, ROM.
MCU operation is the same as in mode 6.
3.3.3 Mode 3 (H8S/2398 F-ZTAT Only)
This is a flash memory boot mode. For details, see section 19, ROM.
MCU operation is the same as in mode 7.
3.3.4 Mode 4 (On-Chip ROM Disabled Expansion Mode)
The CPU can access a 16-Mbyte address space in advanced mode. The on-chip ROM is disabled.
Ports A, B and C function as an address bus, ports D and E function as a data bus, and part of port F carries bus control
signals.
The initial bus mode after a reset is 16 bits, with 16-bit access to all areas. However, note that if 8-bit access is designated
by the bus controller for all areas, the bus mode switches to 8 bits.
3.3.5 Mode 5 (On-Chip ROM Disabled Expansion Mode)
The CPU can access a 16-Mbyte address space in advanced mode. The on-chip ROM is disabled.
Ports A, B and C function as an address bus, ports D and E function as a data bus, and part of port F carries bus control
signals.
The initial bus mode after a reset is 8 bits, with 8-bit access to all areas. However, note that if at least one area is
designated for 16-bit access by the bus controller, the bus mode switches to 16 bits and port E becomes a data bus.
3.3.6 Mode 6 (On-Chip ROM Enabled Expansion Mode)
The CPU can access a 16-Mbyte address space in advanced mode. The on-chip ROM is enabled.
Ports A, B and C function as input ports immediately after a reset. They can each be set to output addresses by setting the
corresponding bits in the data direction register (DDR) to 1. Port D functions as a data bus, and part of port F carries bus
control signals.
The initial bus mode after a reset is 8 bits, with 8-bit access to all areas. However, note that if at least one area is
designated for 16-bit access by the bus controller, the bus mode switches to 16 bits and port E becomes a data bus.
Rev.6.00 Oct.28.2004 page 60 of 1016
REJ09B0138-0600H