HD64F2357VF13 Datasheet, PDF (694/1049 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Note on Board Design: When a crystal resonator is connected, the following points should be noted.
Other signal lines should be routed away from the oscillator circuit to prevent induction from interfering with correct
oscillation. See figure 20-4.
When designing the board, place the crystal resonator and its load capacitors as close as possible to the XTAL and
EXTAL pins.
Avoid
C_L2
Signal A Signal B
H8S/2357 Group
XTAL
EXTAL
C_L1
Figure 20-4 Example of Incorrect Board Design
20.3.2 External Clock Input
Circuit Configuration: An external clock signal can be input as shown in the examples in figure 20-5. If the XTAL pin is
left open, make sure that stray capacitance is no more than 10 pF.
In example (b) in fugure 20-5, make sure that the external clock is held high in standby mode.
EXTAL
XTAL
Open
External clock input
(a) XTAL pin left open
EXTAL
XTAL
External clock input
(b) Complementary clock input at XTAL pin
Figure 20-5 External Clock Input (Examples)
External Clock: The external clock signal should have the same frequency as the system clock (ø).
Rev.6.00 Oct.28.2004 page 664 of 1016
REJ09B0138-0600H