HD64F2357VF13 Datasheet, PDF (530/1049 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents

Data Transfer Operations:
• Multiprocessor serial data transmission
Figure 14-10 shows a sample flowchart for multiprocessor serial data transmission.
The following procedure should be used for multiprocessor serial data transmission.
Initialization
Start transmission
Read TDRE flag in SSR
No
TDRE= 1
Yes
Write transmit data to TDR and
set MPBT bit in SSR
Clear TDRE flag to 0
No
All data transmitted?
Yes
Read TEND flag in SSR
No
TEND= 1
Yes
No
Break output?
Yes
[1] ^{[1] SCI initialization:}
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1,
[2]
a frame of 1s is output, and
transmission is enabled.
[2] SCI status check and transmit
data write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. Set the
MPBT bit in SSR to 0 or 1.
Finally, clear the TDRE flag to 0.
[3] Serial transmission continuation
procedure:
To continue serial transmission,
be sure to read 1 from the TDRE
flag to confirm that writing is
[3]
possible, then write data to TDR,
and then clear the TDRE flag to
0. Checking and clearing of the
TDRE flag is automatic when the
DMAC or DTC is activated by a
transmit data empty interrupt
(TXI) request, and data is written
to TDR.
[4] Break output at the end of serial
transmission:
To output a break in serial
transmission, set the port DDR to
[4]
1, clear DR to 0, then clear the
TE bit in SCR to 0.
Clear DR to 0 and set DDR to 1
Clear TE bit in SCR to 0
<End>
Figure 14-10 Sample Multiprocessor Serial Transmission Flowchart
Rev.6.00 Oct.28.2004 page 500 of 1016
REJ09B0138-0600H