|
HD64F2357VF13 Datasheet, PDF (614/1049 Pages) Renesas Technology Corp – Old Company Name in Catalogs and Other Documents | |||
|
◁ |
19.7.2 Flash Memory Control Register 2 (FLMCR2)
Bit
7
6
5
4
3
FLER
â
â
â
â
Initial value 0
0
0
0
0
Read/Write R
â
â
â
â
2
1
0
â
ESU PSU
0
0
0
â
R/W R/W
FLMCR2 is an 8-bit register that monitors the presence or absence of flash memory program/erase protection (error
protection) and performs setup for flash memory program/erase mode. FLMCR2 is initialized to H'00 by a reset, and in
hardware standby mode. The ESU and PSU bits are cleared to 0 in software standby mode, hardware protect mode, and
software protect mode.
When on-chip flash memory is disabled, a read will return H'00.
Bit 7âFlash Memory Error (FLER): Indicates that an error has occurred during an operation on flash memory
(programming or erasing). When FLER is set to 1, flash memory goes to the error-protection state.
Bit 7
FLER
0
1
Description
Flash memory is operating normally
Flash memory program/erase protection (error protection) is disabled
[Clearing condition]
Reset or hardware standby mode
An error has occurred during flash memory programming/erasing
Flash memory program/erase protection (error protection) is enabled
[Setting condition]
See section 19.10.3, Error Protection
(Initial value)
Bits 6 to 2âReserved: These bits cannot be modified and are always read as 0.
Bit 1âErase Setup (ESU): Prepares for a transition to erase mode. Set this bit to 1 before setting the E bit to 1 in
FLMCR1. Do not set the SWE, PSU, EV, PV, E, or P bit at the same time.
Bit 1
ESU
0
1
Description
Erase setup cleared
Erase setup
[Setting condition]
When FWE = 1, and SWE = 1
(Initial value)
Bit 0âProgram Setup (PSU): Prepares for a transition to program mode. Set this bit to 1 before setting the P bit to 1 in
FLMCR1. Do not set the SWE, ESU, EV, PV, E, or P bit at the same time.
Rev.6.00 Oct.28.2004 page 584 of 1016
REJ09B0138-0600H
|
▷ |