MC68HC08AZ0 Datasheet, PDF (241/444 Pages) Motorola, Inc – Advance Information

Freescale Semiconductor, Inc.
Serial Peripheral Interface Module (SPI)
SPI during break interrupts
SPI during break interrupts
The system integration module (SIM) controls whether status bits in
other modules can be cleared during the break state. The BCFE bit in
the SIM break flag control register (SBFCR) enables software to clear
status bits during the break state. See SIM break flag control register
(SBFCR) on page 106.
To allow software to clear status bits during a break interrupt, a ‘1’ should
be written to the BCFE bit. If a status bit is cleared during the break state,
it remains cleared when the MCU exits the break state.
To protect status bits during the break state, a ‘0’ should be written to the
BCFE bit. With BCFE at ‘0’ (its default state), software can read and write
I/O registers during the break state without affecting status bits. Some
status bits have a two-step read/write clearing procedure. If software
does the first step on such a bit before the break, the bit cannot change
during the break state as long as BCFE is a ‘0’. After the break, the
second step clears the status bit.
Since the SPTE bit cannot be cleared during a break with the BCFE bit
cleared, a write to the data register in break mode will not initiate a
transmission, nor will this data be transferred into the shift register.
Therefore, a write to the SPDR in break mode with the BCFE bit cleared
has no effect.
23-spi
MOTOROLA
Serial Peripheral Interface Module (SPI)
For More Information On This Product,
Go to: www.freescale.com
MC68HC08AZ0
239