MC68HC08AZ0 Datasheet, PDF (198/444 Pages) Motorola, Inc – Advance Information

Freescale Semiconductor, Inc.
Serial Communications Interface Module (SCI)
service so that both a read of SCS1 and a read of SCDR are
required to clear the SCRF bit. Setting SCRIE enables DMA
service so that the DMA can recognize a service request that
occurred during the error-servicing interrupt routine.
c. In the CPU interrupt routine to service error bits, do not use
BRSET or BRCLR instructions. BRSET and BRCLR read the
SCS1 register, which is the first step in clearing the register.
Then the DMA could read the SCI data register, the second
step in clearing it, thereby clearing all error bits. The next read
of the data register would miss any error bits that were set.
2. DMA latency should be short enough so that an SCRF is serviced
before the next SCRF occurs. If DMA latency is long enough for a
new SCRF to occur before servicing an error bit, then:
a. Overruns occur. Set the ORIE bit to enable SCI error CPU
interrupt requests and service the overrun in an interrupt
routine. In a message-based system, disable the DMA in the
interrupt routine and manually recover. Otherwise, the byte
that was lost in the overrun could prevent the DMA from
reaching its byte count. If the DMA reaches it byte count in the
following message, two messages may be corrupted.
b. If the CPU does not service an overrun interrupt request, the
DMA can eventually clear the SCRF bit by reading the SCI
data register. The OR bit remains set. Each time a new byte
sets the SCRF bit, new data transfers from the shift register to
the SCI data register (provided that another overrun does not
occur), even though the OR bit is set. The DMA removed the
overrun condition by reading the data register, but the OR bit
has not been cleared.
MC68HC08AZ0
196
Serial Communications Interface Module (SCI)
For More Information On This Product,
Go to: www.freescale.com
18-sci
MOTOROLA