M1AFS600-PQ208 Datasheet, PDF (33/334 Pages) Microsemi Corporation – Fusion Family of Mixed Signal FPGAs

Fusion Family of Mixed Signal FPGAs
VersaNet Timing Characteristics
Global clock delays include the central rib delay, the spine delay, and the row delay. Delays do not
include I/O input buffer clock delays, as these are dependent upon I/O standard, and the clock may be
driven and conditioned internally by the CCC module. Table 2-5, Table 2-6, Table 2-7, and Table 2-8 on
page 2-18 present minimum and maximum global clock delays within the device Minimum and maximum
delays are measured with minimum and maximum loading, respectively.
Timing Characteristics
Table 2-5 • AFS1500 Global Resource Timing
Commercial Temperature Range Conditions: T_J = 70°C, Worst-Case VCC = 1.425 V
–2
–1
Std.
Parameter
Description
Min.¹ Max.² Min.¹ Max.² Min.¹ Max.²
Units
t_RCKL
Input Low Delay for Global Clock
1.53 1.75 1.74 1.99 2.05 2.34 ns
t_RCKH
Input High Delay for Global Clock
1.53 1.79 1.75 2.04 2.05 2.40 ns
t_RCKMPWH Minimum Pulse Width High for Global Clock
ns
t_RCKMPWL Minimum Pulse Width Low for Global Clock
ns
t_RCKSW
Maximum Skew for Global Clock
0.26
0.29
0.34 ns
Notes:
1. Value reflects minimum load. The delay is measured from the CCC output to the clock pin of a sequential element
located in a lightly loaded row (single element is connected to the global net).
2. Value reflects maximum load. The delay is measured on the clock pin of the farthest sequential element located in a
fully loaded row (all available flip-flops are connected to the global net in the row).
3. For the derating values at specific junction temperature and voltage supply levels, refer to Table 3-7 on page 3-9.
Table 2-6 • AFS600 Global Resource Timing
Commercial Temperature Range Conditions: T_J = 70°C, Worst-Case VCC = 1.425 V
–2
–1
Std.
Parameter
Description
Min.¹ Max.² Min.¹ Max.² Min.¹ Max.²
Units
t_RCKL
Input Low Delay for Global Clock
1.27 1.49 1.44 1.70 1.69 2.00 ns
t_RCKH
Input High Delay for Global Clock
1.26 1.54 1.44 1.75 1.69 2.06 ns
t_RCKMPWH Minimum Pulse Width High for Global Clock
ns
t_RCKMPWL Minimum Pulse Width Low for Global Clock
ns
t_RCKSW
Maximum Skew for Global Clock
0.27
0.31
0.36 ns
Notes:
1. Value reflects minimum load. The delay is measured from the CCC output to the clock pin of a sequential element
located in a lightly loaded row (single element is connected to the global net).
2. Value reflects maximum load. The delay is measured on the clock pin of the farthest sequential element located in a
fully loaded row (all available flip-flops are connected to the global net in the row).
3. For the derating values at specific junction temperature and voltage supply levels, refer to Table 3-7 on page 3-9.
Revision 4
2- 17