M1AFS600-PQ208 Datasheet, PDF (324/334 Pages) Microsemi Corporation – Fusion Family of Mixed Signal FPGAs

Datasheet Information
Revision
Advance v1.5
(continued)
Advance v1.4
(July 2008)
Advance v1.3
(July 2008)
Advance v1.2
(May 2008)
Advance v1.1
(May 2008)
Changes
This bullet was added to the "Integrated A/D Converter (ADC) and Analog I/O"
section: ADC Accuracy is Better than 1%
In the "Integrated Analog Blocks and Analog I/Os" section, ±4 LSB was changed to
0.72. The following sentence was deleted:
The input range for voltage signals is from –12 V to +12 V with full-scale output
values from 0.125 V to 16 V.
In addition, 2°C was changed to 3°C:
"One analog input in each quad can be connected to an external temperature
monitor diode and achieves detection accuracy of ±3ºC."
The following sentence was deleted:
The input range for voltage signals is from –12 V to +12 V with full-scale output
values from 0.125 V to 16 V.
The title of the datasheet changed from Actel Programmable System Chips to Actel
Fusion Mixed Signal FPGAs. In addition, all instances of programmable system chip
were changed to mixed signal FPGA.
In Table 3-8 · Quiescent Supply Current Characteristics (IDDQ)1, footnote
references were updated for I_DC2 and I_DC3.
Footnote 3 and 4 were updated and footnote 5 is new.
The "ADC Description" section was significantly updated. Please review carefully.
Page
I
1-4
N/A
3-11
2-102
Table 2-25 • Flash Memory Block Timing was significantly updated.
The "V_AREF Analog Reference Voltage" pin description section was significantly
update. Please review it carefully.
Table 2-45 • ADC Interface Timing was significantly updated.
Table 2-56 • Direct Analog Input Switch Control Truth Table—AV (x = 0), AC (x = 1),
and AT (x = 3) was significantly updated.
The following sentence was deleted from the "Voltage Monitor" section:
The Analog Quad inputs are tolerant up to 12 V + 10%.
The "180-Pin QFN" figure was updated. D1 to D4 are new and the figure was
changed to bottom view. The note below the figure is new.
The following text was incorrect and therefore deleted:
VCC33A
Analog Power Filter
Analog power pin for the analog power supply low-pass filter. An external 100 pF
capacitor should be connected between this pin and ground.
There is still a description of V_CC33A on page 2-224.
2-55
2-226
2-110
2-131
2-86
3-3
2-204
5-8
Revision 4