M1AFS600-PQ208 Datasheet, PDF (327/334 Pages) Microsemi Corporation – Fusion Family of Mixed Signal FPGAs

Fusion Family of Mixed Signal FPGAs
Revision
Advance v1.0
(continued)
Advance v0.9
(October 2007)
Advance v0.9
(continued)
Advance v0.8
(June 2007)
Changes
Page
This change table states that in the "208-Pin PQFP" table listed under the Advance 3-8
v0.8 changes, the AFS090 device had a pin change. That is incorrect. Pin 102 was
updated for AFS250 and AFS600. The function name changed from V_CC33ACAP to
V_CC33A.
In the "Package I/Os: Single-/Double-Ended (Analog)" table, the
II
AFS1500/M7AFS1500 I/O counts were updated for the following devices:
FG484: 223/109
FG676: 252/126
In the "108-Pin QFN" table, the function changed from V_CC33ACAP to V_CC33A for the 3-2
following pin:
B25
In the "180-Pin QFN" table, the function changed from V_CC33ACAP to V_CC33A for the 3-4
following pins:
AFS090: B29
AFS250: B29
In the "208-Pin PQFP" table, the function changed from V_CC33ACAP to V_CC33A for the 3-8
following pins:
AFS090: 102
AFS250: 102
In the "256-Pin FBGA" table, the function changed from V_CC33ACAP to V_CC33A for the
following pins:
AFS090: T14
AFS250: T14
AFS600: T14
AFS1500: T14
3-12
In the "484-Pin FBGA" table, the function changed from V_CC33ACAP to V_CC33A for the
following pins:
AFS600: AB18
AFS1500: AB18
3-20
In the "676-Pin FBGA" table, the function changed from V_CC33ACAP to V_CC33A for the
following pins:
AFS1500: AD20
3-28
Figure 2-16 • Fusion Clocking Options and the "RC Oscillator" section were updated 2-20, 2-21
to change GND_OSC and VCC_OSC to GNDOSC and VCCOSC.
Figure 2-19 • Fusion CCC Options: Global Buffers with the PLL Macro was updated
to change the positions of OADIVRST and OADIVHALF, and a note was added.
2-25
The "Crystal Oscillator" section was updated to include information about controlling
and enabling/disabling the crystal oscillator.
2-22
Table 2-11 · Electrical Characteristics of the Crystal Oscillator was updated to
change the typical value of I_DYNXTAL for 0.032–0.2 MHz to 0.19.
The "1.5 V Voltage Regulator" section was updated to add "or floating" in the
paragraph stating that an external pull-down is required on TRST to power down the
VR.
2-24
2-41
The "1.5 V Voltage Regulator" section was updated to include information on
powering down with the VR.
2-41
Revision 4
5- 11