SH7708 Datasheet, PDF (397/633 Pages) Renesas Technology Corp – SuperH™ RISC engine

In transmitting serial data, the SCI operates as follows:
1. The SCI monitors the TDRE bit in SCSSR. When TDRE is cleared to 0 the SCI recognizes
that the transmit data register (SCTDR) contains new data, and loads this data from SCTDR
into the transmit shift register (SCTSR).
2. After loading the data from SCTDR into SCTSR, the SCI sets the TDRE bit to 1 and starts
transmitting. If the transmit-data-empty interrupt enable bit (TIE) in the SCSCR is set to 1, the
SCI requests a transmit-data-empty interrupt (TXI) at this time. Serial transmit data is
transmitted in the following order from the TxD pin:
a. Start bit: One 0 bit is output.
b. Transmit data: Seven or eight bits are output, LSB first.
c. Multiprocessor bit: One multiprocessor bit (MPBT value) is output.
d. Stop bit: One or two 1 bits (stop bits) are output.
e. Marking: Output of 1 bits continues until the start bit of the next transmit data.
3. The SCI checks the TDRE bit when it outputs the stop bit. If TDRE is 0, the SCI loads data
from SCTDR into SCTSR, outputs the stop bit, then begins serial transmission of the next
frame. If TDRE is 1, the SCI sets the TEND bit in SCSSR to 1, outputs the stop bit, then
continues output of 1 bits in the mark state. If the transmit-end interrupt enable bit (TEIE) in
the SCSCR is set to 1, a transmit-end interrupt (TEI) is requested at this time.
379