M32C8A Datasheet, PDF (37/372 Pages) Renesas Technology Corp – RENESAS MCU M16C FAMILY / M32C/80 Series

M32C/8A Group
2. Central Processing Unit (CPU)
2.1.8.7 Interrupt Enable Flag (I)
The I flag enables maskable interrupts.
Interrupts are disabled when the I flag is set to 0 and enabled when it is set to 1. The I flag becomes 0 when
an interrupt request is acknowledged.
2.1.8.8 Stack Pointer Select Flag (U)
ISP is selected when the U flag is set to 0. USP is selected when the U flag is set to 1.
The U flag becomes 0 when a hardware interrupt request is acknowledged or the INT instruction specifying
software interrupt numbers 0 to 31 is executed.
2.1.8.9 Processor Interrupt Priority Level (IPL)
IPL is 3 bits wide and assigns processor interrupt priority levels from level 0 to level 7.
If a requested interrupt has higher priority than IPL, the interrupt is enabled.
2.1.8.10 Reserved Space
Only write 0 to bits assigned to the reserved space. When read, the bits return undefined values.
2.2 High-Speed Interrupt Registers
Registers associated with the high-speed interrupt are follows:
• Save flag register (SVF)
• Save PC register (SVP)
• Vector register (VCT)
Refer to 11.4 High-Speed Interrupt for details.
2.3 DMAC-Associated Registers
Registers associated with the DMAC are as follows:
• DMA mode register (DMD0, DMD1)
• DMA transfer count register (DCT0, DCT1)
• DMA transfer count reload register (DRC0, DRC1)
• DMA memory address register (DMA0, DMA1)
• DMA memory address reload register (DRA0, DRA1)
• DMA SFR address register (DSA0, DSA1)
Refer to 13. DMAC for details.
Rev.1.00 Jul 15, 2007 Page 20 of 352
REJ09B0385-0100