SH7618 Datasheet, PDF (365/646 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7618 Series

Section 14 Serial Communication Interface with FIFO (SCIF)
Initial
Bit
Bit Name value R/W Description
3
STOP
0
R/W Stop Bit Length
Selects one or two bits as the stop bit length in
asynchronous mode. This setting is used only in
asynchronous mode. It is ignored in synchronous mode
because no stop bits are added.
When receiving, only the first stop bit is checked,
regardless of the STOP bit setting. If the second stop
bit is 1, it is treated as a stop bit, but if the second stop
bit is 0, it is treated as the start bit of the next incoming
character.
0: One stop bit
When transmitting, a single 1-bit is added at the end
of each transmitted character.
1: Two stop bits
When transmitting, two 1 bits are added at the end of
each transmitted character.
2

0
R Reserved
This bit is always read as 0. The write value should
always be 0.
1
CKS1
0
R/W Clock Select 1 and 0
0
CKS0
0
R/W Select the internal clock source of the on-chip baud rate
generator. Four clock sources are available. Pφ, Pφ/4,
Pφ/16 and Pφ/64. For further information on the clock
source, bit rate register settings, and baud rate, see
section 14.3.8, Bit Rate Register (SCBRR).
00: Pφ
01: Pφ/4
10: Pφ/16
11: Pφ/64
Note: Pφ: Peripheral clock
Rev. 6.00 Jun. 12, 2007 Page 333 of 610
REJ09B0131-0600