SH7201 Datasheet, PDF (260/1196 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7200 Series

Section 9 Bus State Controller (BSC)
Bit
11 to 9
Initial
Bit Name Value
R/W
DPCG[2:0] Undefined R/W
8
DWR
0
R/W
7 to 3 
All 0
R
2 to 0 DCL[2:0] Undefined R/W
[Legend]
x: Don't care
Description
Row Precharge Interval Setting
These bits specify the minimum number of cycles that
must elapse between the SDRAM deactivation
command (PRA) and the next valid command.
000: 1 cycles
:
111: 8 cycles
Write Recovery Interval Setting
This bit specifies the minimum interval that must elapse
between the SDRAM write command (WRITE) and
deactivation (PRA).
0: 1 cycles
1: 2 cycles
Reserved
These bits are always read as 0. The write value
should always be 0.
SDRAM Controller Column Latency Setting
These bits specify the column latency of the SDRAM
controller. This setting only affects the latency setting
on the SDRAM controller side. To specify the column
latency for externally connected SDRAM it is
necessary to use the separate SDRAMm mode register
(SDmMOD), which is described below.
000: Setting prohibited
001: 1 cycles
010: 2 cycles
011: 3 cycles
1xx: Setting prohibited
Rev. 2.00 Sep. 07, 2007 Page 232 of 1164
REJ09B0321-0200