SED1354 Datasheet, PDF (416/472 Pages) Epson Company – Color Graphics LCD/CRT Controller

Page 10
Epson Research and Development
Vancouver Design Center
The following figure illustrates a typical memory write cycle on the Power PC system bus.
2.1.3
SYSCLK
TS
TA
A[0:31]
RD/WR
TSIZ[0:1], AT[0:3]
D[0:31]
Transfer Start
Valid
Wait States
Transfer
Complete
Next Transfer
Starts
Figure 2-2: Power PC Memory Write Cycle
If an error occurs, TEA (Transfer Error Acknowledge) is asserted and the bus cycle is
aborted. For example, a peripheral device may assert TEA if a parity error is detected, or
the MPC821 bus controller may assert TEA if no peripheral device responds at the
addressed memory location within a bus time-out period.
For 32-bit transfers, all data lines (D[0:31]) are used and the two low-order address lines
A30 and A31 are ignored. For 16-bit transfers, data lines D0 through D15 are used and
address line A30 is ignored. For 8-bit transfers, data lines D0 through D7 are used and all
address lines (A[0:31]) are used.
Note
This assumes that the Power PC core is operating in big endian mode (typically the case
for embedded systems).
Burst Cycles
Burst memory cycles are used to fill on-chip cache memory and to carry out certain on-chip
DMA operations. They are very similar to normal bus cycles with the following exceptions:
• Always 32-bit.
• Always attempt to transfer four 32-bit words sequentially.
• Always address longword-aligned memory (i.e. A30 and A31 are always 0:0).
• Do not increment address bits A28 and A29 between successive transfers; the addressed
device must increment these address bits internally.
If a peripheral is not capable of supporting burst cycles, it can assert Burst Inhibit (BI)
simultaneously with TA, and the processor will revert to normal bus cycles for the
remaining data transfers.
SED1354
X19A-G-010-04
Interfacing to the Motorola MPC821 Microprocessor
Issue Date: 99/03/10