SED1354 Datasheet, PDF (254/472 Pages) Epson Company – Color Graphics LCD/CRT Controller

Page 6
Epson Research and Development
Vancouver Design Center
Comments
• All numeric values are considered to be hexadecimal unless identified otherwise. For example,
10 = 10h = 16 decimal; 10t = 10 decimal; 010b = 2 decimal.
• Redirecting commands from a script file (PC platform) allows those commands to be executed as
though they were typed.
• The PC must not have more than 12M bytes of memory when used with the SDU1354B0C
board.
• Follow simultaneous display guidelines for correct simultaneous display operation.
• To determine if the CRT will operate correctly when using a dual panel, refer to the “Maximum
Frame Rates” table in the SED1354 “Functional Hardware Specification,” document number
X19A-A-002-xx.
• When editing in 1354CFG with CRT enabled and panel disabled, select “Single Panel” from the
“Edit Panel Setup” submenu.
• When a CRT is enabled, the CRT settings will override the panel settings. If a panel is also used,
the CRT timing values will have to be changed to more closely match the panel's timing.
• A CRT cannot show 15 or 16 bits-per-pixel.
• Do not attach a panel with a 16-bit interface to the SED1354 when a CRT is also attached.
Program Messages
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL can only manage 10 devices
simultaneously.
ERROR: Could not register SED1354FOA device.
A 1354 device was not found at the configured addresses. Check the configuration address using the
1354CFG configuration program.
SED1354
X19A-B-005-04
1354PLAY Diagnostic Utility
Issue Date: 98/10/29