SED1354 Datasheet, PDF (263/472 Pages) Epson Company – Color Graphics LCD/CRT Controller

Epson Research and Development
Vancouver Design Center
Page 5
Program Messages
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument /software was selected more than once. Select /software only once.
ERROR: Already selected HARDWARE.
Command line argument /hardware was selected more than once. Select /hardware only once.
ERROR: Already selected ENABLE.
Command line argument /enable was selected more than once. Select /enable only once.
ERROR: Already selected DISABLE.
Command line argument /disable was selected more than once. Select /disable only once.
ERROR: Select /software or /hardware.
Neither command line argument /software or /hardware was selected. Select /software or
/hardware.
ERROR: Select /enable or /disable.
Neither command line argument /enable or /disable was selected. Select /enable or
/disable.
ERROR: Too many devices registered.
There are too many display devices attached to the HAL. The HAL can only manage 10 devices
simultaneously.
ERROR: Could not register SED1354FOA device.
A 1354 device was not found at the configured addresses. Check the configuration address using the
1354CFG configuration program.
ERROR: Did not detect SED1354.
The HAL was unable to read the revision code register on the SED1354. Ensure that the SED1354
hardware is installed and that the hardware platform has been set up correctly.
1354PWR Software Suspend Power Sequencing Utility
Issue Date: 98/10/29
SED1354
X19A-B-007-03