M16C6NK Datasheet, PDF (349/404 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NK, M16C/6NM)
22. Electric Characteristics (T/V-ver.)
Table 22.49 Electrical Characteristics (1) ⁽¹⁾
Symbol
Parameter
Measuring Condition
Standard
Min. Typ. Max.
Unit
VOH
HIGH Output P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7, IOH = –5mA
Voltage
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
VCC-2.0
VCC
V
P6_0 to P6_7, P7_0, P7_2 to P7_7, P8_0 to P8_4,
P8_6, P8_7, P9_0, P9_2 to P9_7, P10_0 to P10_7,
P11_0 to P11_7, P12_0 to P12_7, P13_0 to P13_7,
P14_0, P14_1
VOH
HIGH Output P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7, IOH = –200µA
Voltage
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
VCC-0.3
VCC
V
P6_0 to P6_7, P7_0, P7_2 to P7_7, P8_0 to P8_4,
P8_6, P8_7, P9_0, P9_2 to P9_7, P10_0 to P10_7,
P11_0 to P11_7, P12_0 to P12_7, P13_0 to P13_7,
P14_0, P14_1
VOH
HIGH Output XOUT HIGHPOWER
Voltage
LOWPOWER
IOH = –1mA
3.0
IOH = –0.5mA
3.0
VCC
V
VCC
HIGH Output XCOUT HIGHPOWER
Voltage
LOWPOWER
With no load applied
2.5
V
With no load applied
1.6
VOL
LOW Output P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7, IOL = 5mA
Voltage
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
2.0 V
P6_0 to P6_7, P7_0 to P7_7, P8_0 to P8_4,
P8_6, P8_7, P9_0 to P9_7, P10_0 to P10_7,
P11_0 to P11_7, P12_0 to P12_7, P13_0 to P13_7,
P14_0, P14_1
VOL
LOW Output ^{P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7,} IOL = 200µA
Voltage
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
0.45 V
P6_0 to P6_7, P7_0 to P7_7, P8_0 to P8_4,
P8_6, P8_7, P9_0 to P9_7, P10_0 to P10_7,
P11_0 to P11_7, P12_0 to P12_7, P13_0 to P13_7,
P14_0, P14_1
VOL
LOW Output ^{XOUT HIGHPOWER}
Voltage
LOWPOWER
IOL = 1mA
IOL = 0.5mA
2.0 V
2.0
LOW Output ^{XCOUT HIGHPOWER}
With no load applied
0
V
Voltage
LOWPOWER
With no load applied
0
_________ _________
VT+-VT- Hysteresis
TA0IN to TA4IN, TB0IN to TB5IN, INT0 to INT8,
________ ______________ __________
__________
0.2
1.0 V
NMI, ADTRG, CTS0 to CTS2, SCL0 to SCL2,
VT+-VT- Hysteresis
VT+-VT- Hysteresis
IIH
HIGH Input
Current
SDA0 to SDA2, CLK0 to CLK6, TA0OUT to TA4OUT,
______
______
KI0 to KI3, RXD0 to RXD2, SIN3 to SIN6
_____________
RESET
XIN
P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7, VI = 5V
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
P6_0 to P6_7, P7_0 to P7_7, P8_0 to P8_7,
0.2
2.5 V
0.2
0.8 V
5.0 µA
P9_0 to P9_7, P10_0 to P10_7, P11_0 to P11_7,
P12_0 to P12_7, P13_0 to P13_7, P14_0, P14_1,
____________
XIN, RESET, CNVSS, BYTE
IIL
LOW Input
P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7, _{VI = 0V}
Current
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
P6_0 to P6_7, P7_0 to P7_7, P8_0 to P8_7,
–5.0 µA
P9_0 to P9_7, P10_0 to P10_7, P11_0 to P11_7,
P12_0 to P12_7, P13_0 to P13_7, P14_0, P14_1,
____________
XIN, RESET, CNVSS, BYTE
RPULLUP Pull-up
Resistance
P0_0 to P0_7, P1_0 to P1_7, P2_0 to P2_7, VI = 0V
P3_0 to P3_7, P4_0 to P4_7, P5_0 to P5_7,
P6_0 to P6_7, P7_0, P7_2 to P7_7, P8_0 to P8_4,
30 50 170 kΩ
P8_6, P8_7, P9_0, P9_2 to P9_7, P10_0 to P10_7,
P11_0 to P11_7, P12_0 to P12_7, P13_0 to P13_7,
P14_0, P14_1
RfXIN
RfXCIN
VRAM
Feedback Resistance XIN
Feedback Resistance XCIN
RAM Retention Voltage
1.5
MΩ
15
MΩ
At stop mode
2.0
V
NOTES:
1. Referenced t_{_}o_{___}V_{___}C_{_} C = 4.2 _{________} to 5.5V, VSS = 0V at Topr = –40 to 85°C, f(BCLK) = 20MHz unless otherwise specified.
2. P11 to P14, INT6 to INT8, CLK5, CLK6, SIN5 and SIN6 are only in the 128-pin version.
Rev.2.00 Nov 28, 2005 page 331 of 378
REJ09B0124-0200