M16C6NK Datasheet, PDF (312/404 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NK, M16C/6NM)
22. Electric Characteristics (Normal-ver.)
Table 22.3 Recommended Operating Conditions (2) ⁽¹⁾
Symbol
Parameter
Standard
Unit
Min. Typ. Max.
f(XIN)
Main Clock Input Oscillation No Wait Mask ROM Version VCC = 3.0 to 5.5V 0
Frequency ^{(2) (3) (4)}
Flash Memory Version
16 MHz
f(XCIN) Sub Clock Oscillation Frequency
32.768 50 kHz
f(Ring)
On-chip Oscillation Frequency
1
MHz
f(PLL)
PLL Clock Oscillation Frequency
16
24 MHz
f(BCLK) CPU Operation Clock
VCC = 3.0 to 5.5V 0
24 MHz
tsu(PLL)
f(ripple)
PLL Frequency Synthesizer Stabilization Wait Time
Power Supply Ripple Allowable Frequency (VCC)
20 ms
10 kHz
VP-P(ripple) Power Supply Ripple Allowable Amplitude Voltage VCC = 5V
0.5 V
VCC = 3V
0.3
VCC(|∆V/∆T|) Power Supply Ripple Rising/Falling Gradient
VCC = 5V
0.3 V/ms
VCC = 3V
0.3
NOTES:
1. Referenced to VCC = 3.0 to 5.5V at Topr = –40 to 85°C unless
otherwise specified.
2. Relationship between main clock oscillation frequency and supply
16.0
Main clock input oscillation frequency
(Mask ROM version / Flash memory
version: no wait)
voltage is shown right.
3. Execute program/erase of flash memory by VCC = 3.3 ± 0.3 V or
VCC = 5.0 ± 0.5 V.
4. When using 16MHz and over, use PLL clock. PLL clock oscillation
frequency which can be used is 16MHz, 20MHz or 24MHz.
0.0
3.0
5.5
VCC [V] (main clock: no division)
f(ripple)
Power Supply Ripple Allowable
Frequency (VCC)
VP-P(ripple)
Power Supply Ripple Allowable
Amplitude Voltage
VCC
Figure 22.1 Timing of Voltage Fluctuation
f(ripple)
VP-P(ripple)
Rev.2.00 Nov 28, 2005 page 294 of 378
REJ09B0124-0200