M16C6NK Datasheet, PDF (126/404 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

Under development
This document is under development and its contents are subject to change.
M16C/6N Group (M16C/6NK, M16C/6NM)
12. DMAC
12.1 Transfer Cycle
The transfer cycle consists of a memory or SFR read (source read) bus cycle and a write (destination write)
bus cycle. The number of read and write bus cycles is affected by the source and destination addresses of
transfer. During memory expansion and microprocessor modes, it is also affected by the BYTE pin level ⁽¹⁾.
________
Furthermore, the bus cycle itself is extended by a software wait or RDY signal ⁽²⁾.
NOTES:
1. Not available memory expansion and microprocessor modes in T/V-ver..
2. Not available the bus control pins in T/V-ver..
12.1.1 Effect of Source and Destination Addresses
If the transfer unit and data bus both are 16 bits and the source address of transfer begins with an odd
address, the source read cycle consists of one more bus cycle than when the source address of transfer
begins with an even address.
Similarly, if the transfer unit and data bus both are 16 bits and the destination address of transfer begins
with an odd address, the destination write cycle consists of one more bus cycle than when the destination
address of transfer begins with an even address.
12.1.2 Effect of BYTE Pin Level ⁽¹⁾
During memory expansion and microprocessor modes, if 16 bits of data are to be transferred on an 8-bit
data bus (input on the BYTE pin = high), the operation is accomplished by transferring 8 bits of data twice.
Therefore, this operation requires two bus cycles to read data and two bus cycles to write data.
Furthermore, if the DMAC is to access the internal area (internal ROM, internal RAM, or SFR), unlike in
the case of the CPU, the DMAC does it through the data bus width selected by the BYTE pin.
NOTE:
1. Not available the bus control pins in T/V-ver..
12.1.3 Effect of Software Wait
For memory or SFR accesses in which one or more software wait states are inserted, the number of bus
cycles required for that access increases by an amount equal to software wait states.
Figure 12.5 shows the example of the transfer cycles for a source read. For convenience, the destination
write cycle is shown as one cycle and the source read cycles for the different conditions are shown. In
reality, the destination write cycle is subject to the same conditions as the source read cycle, with the
transfer cycle changing accordingly. When calculating transfer cycles, take into consideration each
condition for the source read and the destination write cycle, respectively. For example, when data is
transferred in 16-bit unit using an 8-bit bus ((2) on Figure 12.5), two source read bus cycles and two
destination write bus cycles are required.
________
12.1.4 Effect of RDY Signal ⁽¹⁾
During memory expansion and microprocessor modes, DMA transfers to and from an external area are
________
________
affected by the RDY signal. Refer to 7.2.6 RDY Signal.
NOTE:
1. Not available the bus control pins in T/V-ver..
Rev.2.00 Nov 28, 2005 page 108 of 378
REJ09B0124-0200