PIC18F97J60 Datasheet, PDF (348/474 Pages) Microchip Technology – 64/80/100-Pin, High-Performance, 1 Mbit Flash Microcontrollers with Ethernet

PIC18F97J60 FAMILY
TABLE 24-1: CONFIGURATION BITS AND DEVICE IDs
File Name
Bit 7 Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Default/
Unprogrammed
Value⁽¹⁾
300000h CONFIG1L DEBUG XINST STVREN
300001h CONFIG1H —⁽²⁾
—⁽²⁾
—⁽²⁾
—
—⁽²⁾
—
—⁽³⁾
—
CP0
—
WDTEN 111- ---1
—
—
---- 01--
300002h
300003h
300004h
300005h
CONFIG2L
CONFIG2H
CONFIG3L
CONFIG3H
IESO
—⁽²⁾
WAIT⁽⁴⁾
—⁽²⁾
3FFFFEh DEVID1
DEV2
3FFFFFh DEVID2
DEV10
FCMEN
—⁽²⁾
BW⁽⁴⁾
—⁽²⁾
DEV1
DEV9
—
—⁽²⁾
EMB1⁽⁴⁾
—⁽²⁾
DEV0
DEV8
—
—⁽²⁾
EMB0⁽⁴⁾
—⁽²⁾
REV4
DEV7
—
FOSC2 FOSC1 FOSC0
WDTPS3 WDTPS2 WDTPS1 WDTPS0
EASHFT⁽⁴⁾ —
—
—
—
ETHLED ECCPMX⁽⁵⁾ CCP2MX⁽⁵⁾
REV3
REV2
REV1
REV0
DEV6
DEV5
DEV4
DEV3
11-- -111
---- 1111
1111 1---
---- -111
xxxx xxxx⁽⁶⁾
xxxx xxxx⁽⁶⁾
Legend:
Note 1:
2:
3:
4:
5:
6:
x = unknown, u = unchanged, - = unimplemented. Shaded cells are unimplemented, read as ‘0’.
Values reflect the unprogrammed state as received from the factory and following Power-on Resets. In all other Reset
states, the configuration bytes maintain their previously programmed states.
The value of these bits in program memory should always be ‘1’. This ensures that the location is executed as a NOP if it
is accidentally executed.
This bit should always be maintained as ‘0’.
Implemented on 100-pin devices only.
Implemented on 80-pin and 100-pin devices only.
See Register 24-7 and Register 24-8 for DEVID values. These registers are read-only and cannot be programmed by
the user.
DS39762A-page 346
Advance Information
© 2006 Microchip Technology Inc.