SH7101 Datasheet, PDF (254/486 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

8. Multi-Function Timer Pulse Unit (MTU)
8.8 MTU Output Pin Initialization
8.8.1 Operating Modes
The MTU has the following six operating modes. Waveform output is possible in all of these
modes.
• Normal mode (channels 0 to 4)
• PWM mode 1 (channels 0 to 4)
• PWM mode 2 (channels 0 to 2)
• Phase counting modes 1 to 4 (channels 1 and 2)
• Complementary PWM mode (channels 3 and 4)
• Reset-synchronous PWM mode (channels 3 and 4)
The MTU output pin initialization method for each of these modes is described in this section.
8.8.2 Reset Start Operation
The MTU output pins (TIOC*) are initialized low by a reset or in standby mode. Since MTU pin
function selection is performed by the pin function controller (PFC), when the PFC is set, the
MTU pin states at that point are output to the ports. When MTU output is selected by the PFC
immediately after a reset, the MTU output initial level, low, is output directly at the port. When
the active level is low, the system will operate at this point, and therefore the PFC setting should
be made after initialization of the MTU output pins is completed.
Note: Channel number and port notation are substituted for *.
Rev.2.00 Sep. 27, 2007 Page 220 of 448
REJ09B0394-0200