SH7101 Datasheet, PDF (223/486 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

8. Multi-Function Timer Pulse Unit (MTU)
and TIOC0C (set with PFC). When an edge is detected at pin TIOC0A, TIOC0B, or TIOC0C, the
output on/off state is switched automatically.
When the FB bit is 1, the output on/off state is switched when the UF, VF, or WF bit in TGCR is
cleared to 0 or set to 1.
The drive waveforms are output from the complementary PWM mode 6-phase output pins. With
this 6-phase output, in the case of on output, it is possible to use complementary PWM mode
output and perform chopping output by setting the N bit or P bit to 1. When the N bit or P bit is 0,
level output is selected.
The 6-phase output active level (on output level) can be set with the OLSN and OLSP bits in the
timer output control register (TOCR) regardless of the setting of the N and P bits.
External input TIOC0A pin
TIOC0B pin
TIOC0C pin
6-phase output TIOC3B pin
TIOC3D pin
TIOC4A pin
TIOC4C pin
TIOC4B pin
TIOC4D pin
When BDC = 1, N = 0, P = 0, FB = 0, output active level = high
Figure 8.50 Example of Output Phase Switching by External Input (1)
Rev.2.00 Sep. 27, 2007 Page 189 of 448
REJ09B0394-0200