|
S912XEG128J2MAA Datasheet, PDF (757/1324 Pages) Freescale Semiconductor, Inc – Microcontrollers | |||
|
◁ |
Chapter 20 Serial Communication Interface (S12SCIV5)
Enable single-wire operation by setting the LOOPS bit and the receiver source bit, RSRC, in SCI control
register 1 (SCICR1). Setting the LOOPS bit disables the path from the RXD pin to the receiver. Setting
the RSRC bit connects the TXD pin to the receiver. Both the transmitter and receiver must be enabled
(TE = 1 and RE = 1).The TXDIR bit (SCISR2[1]) determines whether the TXD pin is going to be used as
an input (TXDIR = 0) or an output (TXDIR = 1) in this mode of operation.
NOTE
In single-wire operation data from the TXD pin is inverted if RXPOL is set.
20.4.8 Loop Operation
In loop operation the transmitter output goes to the receiver input. The RXD pin is disconnected from the
SCI.
Transmitter
TXD
Receiver
RXD
Figure 20-31. Loop Operation (LOOPS = 1, RSRC = 0)
Enable loop operation by setting the LOOPS bit and clearing the RSRC bit in SCI control register 1
(SCICR1). Setting the LOOPS bit disables the path from the RXD pin to the receiver. Clearing the RSRC
bit connects the transmitter output to the receiver input. Both the transmitter and receiver must be enabled
(TE = 1 and RE = 1).
NOTE
In loop operation data from the transmitter is not recognized by the receiver
if RXPOL and TXPOL are not the same.
20.5 Initialization/Application Information
20.5.1 Reset Initialization
See Section 20.3.2, âRegister Descriptionsâ.
20.5.2 Modes of Operation
20.5.2.1 Run Mode
Normal mode of operation.
To initialize a SCI transmission, see Section 20.4.5.2, âCharacter Transmissionâ.
MC9S12XE-Family Reference Manual Rev. 1.25
Freescale Semiconductor
757
|
▷ |