S912XEG128J2MAA Datasheet, PDF (1177/1324 Pages) Freescale Semiconductor, Inc – Microcontrollers

Chapter 29 1024 KByte Flash Module (S12XFTM1024K5V2)
CAUTION
A Flash word or phrase must be in the erased state before being
programmed. Cumulative programming of bits within a Flash word or
phrase is not allowed.
29.4.2.1 Erase Verify All Blocks Command
The Erase Verify All Blocks command will verify that all P-Flash and D-Flash blocks have been erased.
Table 29-33. Erase Verify All Blocks Command FCCOB Requirements
CCOBIX[2:0]
000
FCCOB Parameters
0x01
Not required
Upon clearing CCIF to launch the Erase Verify All Blocks command, the Memory Controller will verify
that the entire Flash memory space is erased. The CCIF flag will set after the Erase Verify All Blocks
operation has completed.
Table 29-34. Erase Verify All Blocks Command Error Handling
Register
FSTAT
FERSTAT
Error Bit
ACCERR
FPVIOL
MGSTAT1
MGSTAT0
EPVIOLIF
Error Condition
Set if CCOBIX[2:0] != 000 at command launch
Set if a Load Data Field command sequence is currently active
None
Set if any errors have been encountered during the read
Set if any non-correctable errors have been encountered during the read
None
29.4.2.2 Erase Verify Block Command
The Erase Verify Block command allows the user to verify that an entire P-Flash or D-Flash block has been
erased. The FCCOB upper global address bits determine which block must be verified.
Table 29-35. Erase Verify Block Command FCCOB Requirements
CCOBIX[2:0]
000
FCCOB Parameters
0x02
Global address [22:16] of the
Flash block to be verified.
Upon clearing CCIF to launch the Erase Verify Block command, the Memory Controller will verify that
the selected P-Flash or D-Flash block is erased. The CCIF flag will set after the Erase Verify Block
operation has completed.
Freescale Semiconductor
MC9S12XE-Family Reference Manual Rev. 1.25
1177