S912XEG128J2MAA Datasheet, PDF (320/1324 Pages) Freescale Semiconductor, Inc – Microcontrollers

Chapter 8 S12X Debug (S12XDBGV3) Module
Table 8-27. State3 — Sequencer Next State Selection
SC[3:0]
0000
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
Description
Any match triggers to state1
Any match triggers to state2
Any match triggers to Final State
Match0 triggers to State1....... Other matches have no effect
Match0 triggers to State2....... Other matches have no effect
Match0 triggers to Final State.......Match1 triggers to State1...Other matches have no effect
Match1 triggers to State1....... Other matches have no effect
Match1 triggers to State2....... Other matches have no effect
Match1 triggers to Final State....... Other matches have no effect
Match2 triggers to State2....... Match0 triggers to Final State....... Other matches have no effect
Match1 triggers to State1....... Match3 triggers to State2....... Other matches have no effect
Match3 triggers to State2....... Match1 triggers to Final State....... Other matches have no effect
Match2 triggers to Final State....... Other matches have no effect
Match3 triggers to Final State....... Other matches have no effect
Reserved. (No match triggers state sequencer transition)
Reserved. (No match triggers state sequencer transition)
The trigger priorities described in Table 8-42 dictate that in the case of simultaneous matches, the match
on the lower channel number (0,1,2,3) has priority. The SC[3:0] encoding ensures that a match leading to
final state has priority over all other matches.
8.3.2.7.4 Debug Match Flag Register (DBGMFR)
Address: 0x0027
7
6
5
4
R
0
0
0
0
W
Reset
0
0
0
0
= Unimplemented or Reserved
3
MC3
0
2
MC2
0
1
MC1
0
0
MC0
0
Figure 8-12. Debug Match Flag Register (DBGMFR)
Read: If COMRV[1:0] = 11
Write: Never
DBGMFR is visible at 0x0027 only with COMRV[1:0] = 11. It features four flag bits each mapped directly
to a channel. Should a match occur on the channel during the debug session, then the corresponding flag
is set and remains set until the next time the module is armed by writing to the ARM bit. Thus the contents
are retained after a debug session for evaluation purposes. These flags cannot be cleared by software, they
are cleared only when arming the module. A set flag does not inhibit the setting of other flags. Once a flag
is set, further triggers on the same channel have no affect.
MC9S12XE-Family Reference Manual Rev. 1.25
320
Freescale Semiconductor