S9S12XS256J0CAL Datasheet, PDF (735/738 Pages) Freescale Semiconductor, Inc – Microcontrollers

Appendix F
Ordering Information
Ordering Information
F.1 Ordering Information
The following figure provides an ordering part number example for the devices covered by this data book.
There are two options when ordering a device. Customers must choose between ordering either the mask-
specific part number or the generic / mask-independent part number. Ordering the mask-specific part
number enables the customer to specify which particular maskset they will receive whereas ordering the
generic maskset means that FSL will ship the currently preferred maskset (which may change over time).
In either case, the marking on the device will always show the generic / mask-independent peritoneums
and the mask set number.
NOTE
The max length for the part number is 15 characters. Due to this limitation,
in some situations, some characters are omitted. The mask identifier suffix
and the Tape & Reel suffix are often both omitted from the part number
which is actually marked on the device.
For specific part numbers to order, please contact your local sales office. The below figure illustrates the
structure of a typical mask-specific ordering number for the S12XS family devices.
S 9 S12X S256 J1 C AL R
Tape & Reel:
R = Tape & Reel
No R = No Tape & Reel
Package Option:
AE = 64 LQFP
AA = 80 QFP
AL = 112 LQFP
Temperature Option:
C = -40˚C to 85˚C
V = -40˚C to 105˚C
M = -40˚C to 125˚C
Maskset identifier Suffix:
First digit usually references wafer fab
Second digit usually differentiates mask rev
(this suffix is omitted in generic part numbers)
Device Title
Controller Family
Main Memory Type:
9 = Flash
Status / Partnumber type:
S or SC = Maskset specific part number
MC = Generic / mask-independent part number
P or PC = prototype status (pre qualification)
Figure F-1. Order Part Number Example
S12XS Family Reference Manual, Rev. 1.13
Freescale Semiconductor
735