|
S9S12XS256J0CAL Datasheet, PDF (165/738 Pages) Freescale Semiconductor, Inc – Microcontrollers | |||
|
◁ |
4.5 Initialization/Application Information
Interrupt (S12XINTV2)
4.5.1 Initialization
After system reset, software should:
⢠Initialize the interrupt vector base register if the interrupt vector table is not located at the default
location (0xFF10â0xFFF9).
⢠Initialize the interrupt processing level conï¬guration data registers (INT_CFADDR,
INT_CFDATA0â7) for all interrupt vector requests with the desired priority levels and the request
target (CPU or XGATE module). It might be a good idea to disable unused interrupt requests.
⢠If the XGATE module is used, setup the XGATE interrupt priority register (INT_XGPRIO) and
conï¬gure the XGATE module (please refer the XGATE Block Guide for details).
⢠Enable I maskable interrupts by clearing the I bit in the CCR.
⢠Enable the X maskable interrupt by clearing the X bit in the CCR (if required).
4.5.2 Interrupt Nesting
The interrupt request priority level scheme makes it possible to implement priority based interrupt request
nesting for the I bit maskable interrupt requests handled by the CPU.
⢠I bit maskable interrupt requests can be interrupted by an interrupt request with a higher priority,
so that there can be up to seven nested I bit maskable interrupt requests at a time (refer to Figure 4-
14 for an example using up to three nested interrupt requests).
I bit maskable interrupt requests cannot be interrupted by other I bit maskable interrupt requests per
default. In order to make an interrupt service routine (ISR) interruptible, the ISR must explicitly clear the
I bit in the CCR (CLI). After clearing the I bit, I bit maskable interrupt requests with higher priority can
interrupt the current ISR.
An ISR of an interruptible I bit maskable interrupt request could basically look like this:
⢠Service interrupt, e.g., clear interrupt ï¬ags, copy data, etc.
⢠Clear I bit in the CCR by executing the instruction CLI (thus allowing interrupt requests with
higher priority)
⢠Process data
⢠Return from interrupt by executing the instruction RTI
S12XS Family Reference Manual, Rev. 1.13
Freescale Semiconductor
165
|
▷ |