 English |
|
|
|
|
|
|
|
| S9S12XS256J0CAL Datasheet, PDF (236/738 Pages) Freescale Semiconductor, Inc – Microcontrollers | |||
| |||
| ◁ |
Security (S12XS9SECV2)
7.1.7 Complete Memory Erase (Special Modes)
The microcontroller can be unsecured in special modes by erasing the entire EEPROM and Flash memory
contents.
When a secure microcontroller is reset into special single chip mode (SS), the BDM ï¬rmware veriï¬es
whether the EEPROM and Flash memory are erased. If any EEPROM or Flash memory address is not
erased, only BDM hardware commands are enabled. BDM hardware commands can then be used to write
to the EEPROM and Flash registers to mass erase the EEPROM and all Flash memory blocks.
When next reset into special single chip mode, the BDM ï¬rmware will again verify whether all EEPROM
and Flash memory are erased, and this being the case, will enable all BDM commands, allowing the Flash
options/security byte to be programmed to the unsecured value. The security bits SEC[1:0] in the Flash
security register will indicate the unsecure state following the next reset.
S12XS Family Reference Manual, Rev. 1.13
236
Freescale Semiconductor
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese