XRT79L71_1 Datasheet, PDF (163/434 Pages) Exar Corporation – 1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC -

REV. 1.0.0
XRT79L71
1-CHANNEL DS3/E3 ATM UNI/PPP/CLEAR-CHANNEL FRAMER IC - REGISTER/MAP DESCRIPTION
BIT NUMBER
NAME
3
F Bit Mask [3]/FEAC Bit
(C13)
TYPE
R/W
DESCRIPTION
Transmit F-Bit Error - Bit 4/FEAC Bit (C13):
The exact function of this register bit depends upon the following
parameters.· Whenever the XRT79L71 has been configured to
operate in the Clear-Channel Framer Mode, or not.· Whether Bit
7 (TxOHSrc), within the Test Register (Address = 0x110C) is set
to "1" or "0".
If the XRT79L71 is NOT configured to operate in the Clear-
Channel Framer Mode, OR if TxOHSrc = "0" - Transmit F-Bit
Error - Bit 4:
This READ/WRITE bit-field permits the user to configure the
Transmit DS3 Framer block to transmit DS3 frames with an
erred F bit.
This F-bit corresponds with the 4th F-bit, within a given outbound
DS3 frame. The Transmit DS3 Framer block will perform an
XOR operation with the contents of this bit-field and value of the
4th F-bit. The results of this calculation will be written back into
the 4th F-bit position, within each outbound DS3 frame.
The user should set this bit-field to "0" for normal (e.g., un-erred)
operation.
If the XRT79L71 is configured to operate in the Clear-Chan-
nel Framer Mode, AND if TxOHSrc = "1" - Insert Enable for
FEAC or C13 bit:
This READ/WRITE bit-field permits the user to configure the
Transmit Payload Data Input Interface block to externally accept
an overhead bit and insert it into the FEAC (or C13) bit-field,
within the outbound DS3 data-stream.
0 - Configures the Transmit Direction circuitry to externally
accept and insert data into this overhead bit-field.
1- Configures the Transmit Direction circuitry to NOT externally
accept and insert data into this overhead bit-field.
154