XC164-16 Datasheet, PDF (208/417 Pages) Infineon Technologies AG – 16-Bit Single-Chip Microcontroller with C166SV2 Core Volume 2 (of 2): Peripheral Units

Field
TRPM2
TRPM1,
TRPM0
XC164-16 Derivatives
Peripheral Units (Vol. 2 of 2)
Capture/Compare Unit 6 (CAPCOM6)
Bits Type Description
2
rw
Trap Mode Control Bit 2
This bit controls whether the Trap State Exit is
initiated by hardware or by software.
0 Trap State Exit initiated by HW. Bit TRPF is
automatically cleared by HW if the input pin
CTRAP becomes inactive (CTRAP = 1).
1 Trap State Exit initiated by SW. Bit TRPF must
be reset by SW after the input CTRAP
becomes inactive (CTRAP = 1).
[1:0] rw
Trap Mode Control Bits 1, 0
These two bits control the termination of the Trap
State. When the Trap Flag TRPF is reset to 0, the
Trap State Bit TRPS is reset and the Trap State is left
according to the following options:
00 T12 Synchronization: Reset of TRPS and Trap
State Exit on a T12 Zero-Match (T12_ZM).
01 T13 Synchronization: Reset of TRPS and Trap
State Exit on a T13 Zero-Match (T13_ZM).
10 Reserved, no action.
11 No Synchronization: Reset of TRPS and Trap
State Exit immediately after reset of the Trap
Flag TRPF.
User’s Manual
CAPCOM6_X, V2.0
18-64
V2.1, 2004-03