EP1SGX10DF672C6 Datasheet, PDF (186/272 Pages) Altera Corporation – Section I. Stratix GX Device Family Data Sheet

I/O Structure
However, there is additional resistance present between the device ball
and the input of the receiver buffer, as shown in Figure 4–71. This
resistance is because of package trace resistance (which can be calculated
as the resistance from the package ball to the pad) and the parasitic layout
metal routing resistance (which is shown between the pad and the
intersection of the on-chip termination and input buffer).
Figure 4–71. Differential Resistance of LVDS Differential Pin Pair (R_D)
Package Ball
Pad
0.3 Ω
9.3 Ω
LVDS
Input Buffer
R_D
0.3 Ω
9.3 Ω
Package Ball
Pad
Differential On-Chip
Termination Resistor
Table 4–31 defines the specification for internal termination resistance for
commercial devices.
Table 4–31. Differential On-Chip Termination
Symbol
Description
R_D (2)
Internal differential termination for LVDS
Conditions
Commercial (1), (3)
Industrial (2), (3)
Resistance
Unit
Min Typ Max
110 135 165 Ω
100 135 170 Ω
Notes to Table 4–31:
(1) Data measured over minimum conditions (T_j = 0 C, V_{C C I O} +5%) and maximum conditions (T_j = 85 C,
V_CCIO = –5%).
(2) Data measured over minimum conditions (T_j = –40 C, V_CCIO +5%) and maximum conditions (T_j = 100 C,
V_CCIO = –5%).
(3) LVDS data rate is supported for 840 Mbps using internal differential termination.
MultiVolt I/O Interface
The Stratix GX architecture supports the MultiVolt I/O interface feature,
which allows Stratix GX devices in all packages to interface with systems
of different supply voltages.
The Stratix GX VCCINT pins must always be connected to a 1.5-V power
supply. With a 1.5-V V_CCINT level, input pins are 1.5-V, 1.8-V, 2.5-V, and
3.3-V tolerant. The VCCIO pins can be connected to either a 1.5-V, 1.8-V,
4–120
Stratix GX Device Handbook, Volume 1
Altera Corporation
February 2005