M16C62P_06 Datasheet, PDF (328/421 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

M16C/62P Group (M16C/62P, M16C/62PT)
23. Electrical Characteristics
Table 23.12 Electrical Characteristics (2) ⁽¹⁾
Symbol
Parameter
Measuring Condition
ICC
Power Supply Current
In single-chip
Mask ROM
f(BCLK)=24MHz
(VCC1=VCC2=4.0V to 5.5V) mode, the output
No division, PLL operation
pins are open and
other pins are VSS
No division,
On-chip oscillation
Flash
f(BCLK)=24MHz,
Memory
No division, PLL operation
No division,
On-chip oscillation
Flash Memory f(BCLK)=10MHz,
Program
VCC1=5.0V
Flash Memory f(BCLK)=10MHz,
Erase
VCC1=5.0V
Mask ROM
f(XCIN)=32kHz
Low power dissipation
mode, ROM ⁽³⁾
Flash Memory f(BCLK)=32kHz
Low power dissipation
mode, RAM ⁽³⁾
f(BCLK)=32kHz
Low power dissipation
mode, Flash Memory ⁽³⁾
On-chip oscillation,
Wait mode
Mask ROM
f(BCLK)=32kHz
Flash Memory ^{Wait mode (2),}
Oscillation capability High
f(BCLK)=32kHz
Wait mode ⁽²⁾,
Oscillation capability Low
Stop mode
Topr =25°C
Idet4
Low Voltage Detection Dissipation Current ⁽⁴⁾
Idet3
Reset Area Detection Dissipation Current ⁽⁴⁾
Standard
Unit
Min. Typ. Max.
14 20 mA
1
mA
18 27 mA
1.8
mA
15
mA
25
mA
25
µA
25
µA
420
µA
50
µA
7.5
µA
2.0
µA
0.8 3.0 µA
0.7
4 µA
1.2
8 µA
NOTES:
1. Referenced to VCC1=VCC2=4.2 to 5.5V, VSS = 0V at Topr = −20 to 85°C / −40 to 85°C, f(BCLK)=24MHz unless otherwise
specified.
2. With one timer operated using fC32.
3. This indicates the memory in which the program to be executed exists.
4. Idet is dissipation current when the following bit is set to “1” (detection circuit enabled).
Idet4: VC27 bit in the VCR2 register
Idet3: VC26 bit in the VCR2 register
Rev.2.41 Jan 10, 2006 Page 313 of 390
REJ09B0185-0241