M16C62P_06 Datasheet, PDF (255/421 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

M16C/62P Group (M16C/62P, M16C/62PT)
18. A/D Converter
18.1.2 Repeat Mode
In repeat mode, analog voltage applied to a selected pin is repeatedly converted to a digital code. Table 18.3
shows the Repeat Mode Specifications. Figure 18.6 shows the ADCON0 and ADCON1 Registers (Repeat
Mode).
Table 18.3 Repeat Mode Specifications
Item
Function
A/D Conversion Start
Condition
A/D Conversion Stop
Condition
Interrupt Request
Generation timing
Analog Input Pin ⁽¹⁾
Specification
The CH2 to CH0 bits in the ADCON0 register, the ADGSEL1 to ADGSEL0 bits
in the ADCON2 register and the OPA1 to OPA0 bits in the ADCON1 register
select a pin. Analog voltage applied to this pin is repeatedly converted to a
digital code.
• When the TRG bit in the ADCON0 register is “0” (software trigger)
The ADST bit in the ADCON0 register is set to “1” (A/D conversion starts)
• When the TRG bit is “1” (ADTRG trigger)
Input on the ADTRG pin changes state from high to low after the ADST bit is
set to “1” (A/D conversion starts)
Set the ADST bit to “0” (A/D conversion halted)
None generated
Select one pin from AN0 to AN7, AN0_0 to AN0_7, AN2_0 to AN2_7,
ANEX0 to ANEX1
Reading of Result of A/D Read one of the AD0 to AD7 registers that corresponds to the selected pin
Converter
NOTES:
1. If VCC2 < VCC1, do not use AN0_0 to AN0_7 and AN2_0 to AN2_7 as analog input pins.
Rev.2.41 Jan 10, 2006 Page 240 of 390
REJ09B0185-0241