M16C62P_06 Datasheet, PDF (298/421 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/60 SERIES

M16C/62P Group (M16C/62P, M16C/62PT)
22. Flash Memory Version
Transfer the low-power consumption mode or
on-chip oscillator low-power consumption mode
program to a space other than the flash memory
Low-power consumption mode or
on-chip oscillator low-power
consumption mode program
Set the FMR01 bit to “1” after setting it to “0”
(CPU rewrite mode enabled)
Jump to the low-power consumption mode or
on-chip oscillator low-power consumption mode
program transferred to a space other than the
flash memory. (In the following steps, use the
low-power consumption mode or on-chip oscillator
low-power consumption mode program in a space
other than the flash memory.)
Set the FMSTP bit to “1” (The flash memory stops
operating. It is in a low-power consumption state) ⁽¹⁾
Switch clock source of the CPU clock.
The main clock stops.⁽²⁾
Process in low-power consumption mode or
on-chip oscillator low-power consumption mode (4)
Start main
clock
oscillation
Wait until
oscillation
stabilizes
Switch clock
source of the
CPU clock ⁽²⁾
NOTES:
1. Set the FMSTP bit to “1” after the FMR01 bit is set to “1”
(CPU rewrite mode enabled).
2. Wait until clock stabilizes to switch clock source of
the CPU clock to the main clock or sub clock.
3. Add tps µs wait time by program. Do not access the
flash memory during this wait time.
4. Before entering wait mode or stop mode, be sure
to set the FMR01 bit to “0”.
Set the FMSTP bit to “0” (flash memory operation)
Set the FMR01 bit to “0”
(CPU rewrite mode disabled)
Wait until the flash memory stabilizes (tps µs) ⁽³⁾
Jump to a desired address in the flash memory
Figure 22.9 Processing Before and After Low Power Dissipation Mode or On-chip Oscillator Low-
Power Consumption Mode
Rev.2.41 Jan 10, 2006 Page 283 of 390
REJ09B0185-0241