MB87P2020 Datasheet, PDF (273/356 Pages) Fujitsu Component Limited. – Colour LCD/CRT/TV Controller

Electrical Specififcation
Table 2-3: DC characteristics
Parameter Symbol Test conditions
Requirements
Unit
Min
Typ
Max
Low-level out- IOL L type VOL=0.4V
2.0
-
put current
M type VOL=0.4V
4.0
-
-
mA
-
mA
H type VOL=0.4V
8.0
-
-
mA
Input leakage
IL
current per pin^b
-
-
+/-5
uA
Input pull-up/
RP
pull-down
resistor^c
10
25
70
kOhm
Output short- IOS L type
circuit current^d
M type
-
-
+/-40
mA
-
-
+/-60
mA
H type
-
-
+/-120
mA
a.VIH = VDD and VIL = VSS, memory is in stand-by mode, Analog cells (APLL, DACs, DAC-
VREF) are at power down mode, Tj = 25˚C
b.Input pins have to be static. If an input buffer with pull-up/pull-down resistor is used, the input
leakage current may exceed the above value
c.Either a buffer without a resistor or with a pull-up/pull-down resistor can be selected from the
input and bidirectional buffers.
d.Maximum supply current at the short circuit of output and VDD or VSS. For 1 second per pin.
Following table shows current/power consumption for Jasmine under special operating conditions. Core
clock, which has most influence is varied over specified range. Please note, if other parameters varied that
given values can be exceeded.
Table 2-4: Maximum core current consumption for Jasmine
Frequency APLL Divider/Mul-
[MHz]
tiplier Setup^a
Core/Analog
supply [mA]
DRAM supply
[mA]
Power consump-
tion [mW]
16
5/7
84.1
9.2 (3.8)^b
360 (346)
20
5/9
104.4
11.5 (4.8)
421 (403)
36
6 / 20
180.7
20.7 (9.1)
652 (621)
48
5 / 23
232.4
27.6 (10.6)
811 (765)
64
2 / 15
294.0
36.8 (12.6)
1001 (936)
a.Values interpreted with n+1
b.Values for DRAM supply in parenthesis are measured while running an usual application.
Measurement conditions:
• Oscillator 12.0 MHz
• Video clock 13.5 MHz, Pixel Clock (display) 6.0 MHz, ULB_CLK 16 MHz
• VDDI = 2.7V, VDDE = 3.6V
Electrical Specification
Page 273