EZ80L92MCU Datasheet, PDF (184/241 Pages) Zilog, Inc. – eZ80Acclaim Flash Microcontrollers

eZ80L92 MCU
Product Specification
169
Table 92. ZDI Address Match Registers ZDI_ADDR0_L = 00h, ZDI_ADDR0_H = 01h,
ZDI_ADDR0_U = 02h, ZDI_ADDR1_L = 04h, ZDI_ADDR1_H = 05h, ZDI_ADDR1_U =
06h, ZDI_ADDR2_L = 08h, ZDI_ADDR2_H = 09h, ZDI_ADDR2_U = 0Ah,
ZDI_ADDR3_L = 0Ch, ZDI_ADDR3_H = 0Dh, and ZDI_ADDR3_U = 0Eh
in the ZDI Register Write-Only Address Space
Bit
Reset
CPU Access
Note: W = Write-only.
7
6
5
4
3
2
1
0
X
X
X
X
X
X
X
X
W
W
W
W
W
W
W
W
Bit
Position
[7:0]
ZDI_ADDRx_L,
ZDI_ADDRx_H,
or
ZDI_ADDRx_U
Value Description
00h–
FFh
The four sets of ZDI address match registers are used for
setting the addresses for generating break points. The 24-
bit addresses are supplied by {ZDI_ADDRx_U,
ZDI_ADDRx_H, ZDI_ADDRx_L, where x is 0, 1, 2, or 3.
ZDI Break Control Register
The ZDI Break Control register is used to enable break points. ZDI asserts a BREAK
when the CPU instruction address, ADDR[23:0], matches the value in the ZDI Address
Match 3 registers, {ZDI_ADDR3_U, ZDI_ADDR3_H, ZDI_ADDR3_L}. Breaks can
only occur on an instruction boundary. If the instruction address is not the beginning of an
instruction (that is, for multibyte instructions), then the BREAK occurs at the end of the
current instruction. The BRK_NEXT bit is set to 1. The BRK_NEXT bit must be reset to
0 to release the BREAK. See Table 93.
PS013012-1004
PRELIMINARY
ZiLOG Debug Interface