EZ80L92MCU Datasheet, PDF (147/241 Pages) Zilog, Inc. – eZ80Acclaim Flash Microcontrollers

eZ80L92 MCU
Product Specification
132
Upon RESET, the 16-bit BRG divisor value resets to 0002h. When the SPI is operating as
a Master, the BRG divisor value must be set to a value of 0003h or greater. When the SPI
is operating as a Slave, the BRG divisor value must be set to a value of 0004h or greater.
A software Write to either the Low- or High-byte registers for the BRG Divisor Latch
causes both the Low and High bytes to load into the BRG counter, and causes the count to
restart.
Data Transfer Procedure with SPI Configured as the Master
1. Load the SPI Baud Rate Generator Registers, SPI_BRG_H and SPI_BRG_L.
2. External device must deassert the SS pin if currently asserted.
3. Load the SPI Control Register, SPI_CTL.
4. Assert the ENABLE pin of the slave device using a GPIO pin.
5. Load the SPI Transmit Shift Register, SPI_TSR.
6. When the SPI data transfer is complete, deassert the ENABLE pin of the slave device.
Data Transfer Procedure with SPI Configured as a Slave
1. Load the SPI Baud Rate Generator Registers, SPI_BRG_H and SPI_BRG_L.
2. Load the SPI Transmit Shift Register, SPI_TSR. This load cannot occur while the SPI
slave is currently receiving data.
3. Wait for the external SPI Master device to initiate the data transfer by asserting SS.
SPI Registers
There are six registers in the Serial Peripheral Interface which provide control, status, and
data storage functions. The SPI registers are described in the following paragraphs.
SPI Baud Rate Generator Registers—Low Byte and High Byte
These registers hold the Low and High bytes of the 16-bit divisor count loaded by the pro-
cessor for baud rate generation. The 16-bit clock divisor value is returned by
{SPI_BRG_H, SPI_BRG_L}. Upon RESET, the 16-bit BRG divisor value resets to
0002h. When configured as a Master, the 16-bit divisor value must be between 0003h
and FFFFh, inclusive. When configured as a Slave, the 16-bit divisor value must be
between 0004h and FFFFh, inclusive.
A Write to either the Low or High byte registers for the BRG Divisor Latch causes both
bytes to be loaded into the BRG counter and the count restarted. See Tables 69 and 70.
PS013012-1004
PRELIMINARY
Serial Peripheral Interface