MC68HC08AZ60 Datasheet, PDF (238/452 Pages) Motorola, Inc – Advance Information

Freescale Semiconductor, Inc.
Serial Peripheral Interface Module (SPI)
SPWOM — SPI Wired-OR Mode Bit
This read/write bit disables the pullup devices on pins SPSCK, MOSI,
and MISO so that those pins become open-drain outputs.
1 = Wired-OR SPSCK, MOSI, and MISO pins
0 = Normal push-pull SPSCK, MOSI, and MISO pins
SPE — SPI Enable Bit
This read/write bit enables the SPI module. Clearing SPE causes a
partial reset of the SPI (see Resetting the SPI on page 230). Reset
clears the SPE bit.
1 = SPI module enabled
0 = SPI module disabled
SPTIE — SPI Transmit Interrupt Enable Bit
This read/write bit enables CPU interrupt requests generated by the
SPTE bit. SPTE is set when a byte transfers from the transmit data
register to the shift register. Reset clears the SPTIE bit.
1 = SPTE CPU interrupt requests enabled
0 = SPTE CPU interrupt requests disabled
SPI Status and
Control Register
The SPI status and control register contains flags to signal the following
conditions:
• Receive data register full
• Failure to clear SPRF bit before next byte is received (overflow
error)
• Inconsistent logic level on SS pin (mode fault error)
• Transmit data register empty
The SPI status and control register also contains bits that perform these
functions:
• Enable error interrupts
• Enable mode fault error detection
• Select master SPI baud rate
MC68HC08AZ60 — Rev 1.0
238
Serial Peripheral Interface Module (SPI)
For More Information On This Product,
Go to: www.freescale.com
28-spi
MOTOROLA