English
Language : 

MC68HC08AZ60 Datasheet, PDF (237/452 Pages) Motorola, Inc – Advance Information
Freescale Semiconductor, Inc.
Serial Peripheral Interface Module (SPI)
I/O Registers
SPMSTR — SPI Master Bit
This read/write bit selects master mode operation or slave mode
operation. Reset sets the SPMSTR bit.
1 = Master mode
0 = Slave mode
CPOL — Clock Polarity Bit
This read/write bit determines the logic state of the SPSCK pin
between transmissions. (See Figure 3 and Figure 4.) To transmit
data between SPI modules, the SPI modules must have identical
CPOL bits. Reset clears the CPOL bit.
CPHA — Clock Phase Bit
This read/write bit controls the timing relationship between the serial
clock and SPI data. (See Figure 3 and Figure 4.) To transmit data
between SPI modules, the SPI modules must have identical CPHA
bits. When CPHA = 0, the SS pin of the slave SPI module must be set
to logic 1 between bytes. (See Figure 10). Reset sets the CPHA bit.
When CPHA = 0 for a slave, the falling edge of SS indicates the
beginning of the transmission. This causes the SPI to leave its idle
state and begin driving the MISO pin with the MSB of its data. Once
the transmission begins, no new data is allowed into the shift register
from the data register. Therefore, the slave data register must be
loaded with the desired transmit data before the falling edge of SS.
Any data written after the falling edge is stored in the data register and
transferred to the shift register at the current transmission.
When CPHA = 1 for a slave, the first edge of the SPSCK indicates the
beginning of the transmission. The same applies when SS is high for
a slave. The MISO pin is held in a high-impedance state, and the
incoming SPSCK is ignored. In certain cases, it may also cause the
MODF flag to be set. (See Mode Fault Error on page 225). A logic 1
on the SS pin does not in any way affect the state of the SPI state
machine.
27-spi
MOTOROLA
MC68HC08AZ60 — Rev 1.0
Serial Peripheral Interface Module (SPI)
237
For More Information On This Product,
Go to: www.freescale.com