MC9S12HY64 Datasheet, PDF (527/792 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

32 KByte Flash Module (S12FTMRC32K1V1)
Offset Module Base + 0x0005
7
6
5
4
3
2
1
R
0
0
0
0
0
0
DFDIE
W
Reset
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 15-10. Flash Error Configuration Register (FERCNFG)
All assigned bits in the FERCNFG register are readable and writable.
Table 15-13. FERCNFG Field Descriptions
0
SFDIE
0
Field
1
DFDIE
0
SFDIE
Description
Double Bit Fault Detect Interrupt Enable — The DFDIE bit controls interrupt generation when a double bit fault
is detected during a Flash block read operation.
0 DFDIF interrupt disabled
1 An interrupt will be requested whenever the DFDIF flag is set (see Section 15.3.2.8)
Single Bit Fault Detect Interrupt Enable — The SFDIE bit controls interrupt generation when a single bit fault
is detected during a Flash block read operation.
0 SFDIF interrupt disabled whenever the SFDIF flag is set (see Section 15.3.2.8)
1 An interrupt will be requested whenever the SFDIF flag is set (see Section 15.3.2.8)
15.3.2.7 Flash Status Register (FSTAT)
The FSTAT register reports the operational status of the Flash module.
Offset Module Base + 0x0006
R
W
Reset
7
CCIF
1
6
5
4
3
2
0
MGBUSY
RSVD
ACCERR
FPVIOL
0
0
0
0
0
1
0
MGSTAT[1:0]
0¹
0¹
= Unimplemented or Reserved
Figure 15-11. Flash Status Register (FSTAT)
1 _{Reset value can deviate from the value shown if a double bit fault is detected during the reset sequence (see Section 15.6).}
CCIF, ACCERR, and FPVIOL bits are readable and writable, MGBUSY and MGSTAT bits are readable
but not writable, while remaining bits read 0 and are not writable.
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
Freescale Semiconductor
527