MC9S12HY64 Datasheet, PDF (235/792 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

S12 Clock, Reset and Power Management Unit (S12CPMU) Block Description
7.3.2 Register Descriptions
This section describes all the S12CPMU registers and their individual bits.
Address order is as listed in Figure 7-3.
7.3.2.1 S12CPMU Synthesizer Register (CPMUSYNR)
The CPMUSYNR register controls the multiplication factor of the PLL and selects the VCO frequency
range.
0x0034
7
6
5
4
3
2
1
0
R
VCOFRQ[1:0]
W
SYNDIV[5:0]
Reset
0
1
0
1
1
1
1
1
Figure 7-4. S12CPMU Synthesizer Register (CPMUSYNR)
Read: Anytime
Write: If PROT=0 (CPMUPROT register) and PLLSEL=1 (CPMUCLKS register), then write anytime.
Else write has no effect.
NOTE
Writing to this register clears the LOCK and UPOSC status bits.
If PLL has locked (LOCK=1)
fVCO = 2 × fREF × (SYNDIV + 1)
NOTE
f_VCO must be within the specified VCO frequency lock range. Bus
frequency f_bus must not exceed the specified maximum.
The VCOFRQ[1:0] bits are used to configure the VCO gain for optimal stability and lock time. For correct
PLL operation the VCOFRQ[1:0] bits have to be selected according to the actual target VCOCLK
frequency as shown in Table 7-1. Setting the VCOFRQ[1:0] bits incorrectly can result in a non functional
PLL (no locking and/or insufficient stability).
Table 7-1. VCO Clock Frequency Selection
VCOCLK Frequency Ranges
32MHz <= f_VCO<= 48MHz
48MHz < f_VCO<= 64MHz
Reserved
Reserved
VCOFRQ[1:0]
00
01
10
11
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
Freescale Semiconductor
235