MC9S12HY64 Datasheet, PDF (210/792 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

S12S Debug Module (S12SDBGV2)
Priority
Highest
Lowest
Table 6-36. Channel Priorities
Source
TRIG
Channel pointing to Final State
Match0 (force or tag hit)
Match1 (force or tag hit)
Match2 (force or tag hit)
Action
Enter Final State
Transition to next state as defined by state control registers
Transition to next state as defined by state control registers
Transition to next state as defined by state control registers
Transition to next state as defined by state control registers
6.4.4 State Sequence Control
ARM = 0
State 0
(Disarmed)
ARM = 1
ARM = 0
State1
State2
ARM = 0
Session Complete
(Disarm)
Final State
State3
Figure 6-24. State Sequencer Diagram
The state sequencer allows a defined sequence of events to provide a trigger point for tracing of data in the
trace buffer. Once the DBG module has been armed by setting the ARM bit in the DBGC1 register, then
state1 of the state sequencer is entered. Further transitions between the states are then controlled by the
state control registers and channel matches. From Final State the only permitted transition is back to the
disarmed state0. Transition between any of the states 1 to 3 is not restricted. Each transition updates the
SSF[2:0] flags in DBGSR accordingly to indicate the current state.
Alternatively writing to the TRIG bit in DBGSC1, provides an immediate trigger independent of
comparator matches.
Independent of the state sequencer, each comparator channel can be individually configured to generate an
immediate breakpoint when a match occurs through the use of the BRK bits in the DBGxCTL registers.
Thus it is possible to generate an immediate breakpoint on selected channels, whilst a state sequencer
transition can be initiated by a match on other channels. If a debug session is ended by a match on a channel
the state sequencer transitions through Final State for a clock cycle to state0. This is independent of tracing
and breakpoint activity, thus with tracing and breakpoints disabled, the state sequencer enters state0 and
the debug module is disarmed.
6.4.4.1 Final State
On entering Final State a trigger may be issued to the trace buffer according to the trace alignment control
as defined by the TALIGN bit (see 6.3.2.3”). If the TSOURCE bit in DBGTCR is clear then the trace buffer
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
210
Freescale Semiconductor