MC9S12HY64 Datasheet, PDF (204/792 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

S12S Debug Module (S12SDBGV2)
Table 6-30. DBGADHM Field Descriptions
Field
Description
7–0
Bits[15:8]
Comparator Data High Mask Bits — The Comparator data high mask bits control whether the selected
comparator compares the data bus bits [15:8] to the corresponding comparator data compare bits. Data bus
comparisons are only performed if the TAG bit in DBGACTL is clear
0 Do not compare corresponding data bit Any value of corresponding data bit allows match.
1 Compare corresponding data bit
6.3.2.8.8 Debug Comparator Data Low Mask Register (DBGADLM)
Address: 0x002F
R
W
Reset
7
Bit 7
0
6
Bit 6
0
5
Bit 5
0
4
Bit 4
0
3
Bit 3
0
2
Bit 2
0
1
Bit 1
0
0
Bit 0
0
Figure 6-22. Debug Comparator Data Low Mask Register (DBGADLM)
Read: If COMRV[1:0] = 00
Write: If COMRV[1:0] = 00 and DBG not armed.
Table 6-31. DBGADLM Field Descriptions
Field
7–0
Bits[7:0]
Description
Comparator Data Low Mask Bits — The Comparator data low mask bits control whether the selected
comparator compares the data bus bits [7:0] to the corresponding comparator data compare bits. Data bus
comparisons are only performed if the TAG bit in DBGACTL is clear
0 Do not compare corresponding data bit. Any value of corresponding data bit allows match
1 Compare corresponding data bit
6.4 Functional Description
This section provides a complete functional description of the DBG module. If the part is in secure mode,
the DBG module can generate breakpoints but tracing is not possible.
6.4.1 S12SDBG Operation
Arming the DBG module by setting ARM in DBGC1 allows triggering the state sequencer, storing of data
in the trace buffer and generation of breakpoints to the CPU. The DBG module is made up of four main
blocks, the comparators, control logic, the state sequencer, and the trace buffer.
The comparators monitor the bus activity of the CPU. All comparators can be configured to monitor
address bus activity. Comparator A can also be configured to monitor databus activity and mask out
individual data bus bits during a compare. Comparators can be configured to use R/W and word/byte
access qualification in the comparison. A match with a comparator register value can initiate a state
sequencer transition to another state (see Figure 6-24). Either forced or tagged matches are possible. Using
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
204
Freescale Semiconductor