MC9S12HY64 Datasheet, PDF (218/792 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

S12S Debug Module (S12SDBGV2)
If a tracing session is selected by the TSOURCE bit, breakpoints are requested when the tracing session
has completed, thus if Begin aligned triggering is selected, the breakpoint is requested only on completion
of the subsequent trace (see Table 6-42). If no tracing session is selected, breakpoints are requested
immediately.
If the BRK bit is set, then the associated breakpoint is generated immediately independent of tracing
trigger alignment.
Table 6-42. Breakpoint Setup For CPU Breakpoints
BRK
0
0
0
0
1
1
TALIGN
0
0
1
1
x
x
DBGBRK
0
1
0
1
1
0
Breakpoint Alignment
Fill Trace Buffer until trigger then disarm (no breakpoints)
Fill Trace Buffer until trigger, then breakpoint request occurs
Start Trace Buffer at trigger (no breakpoints)
Start Trace Buffer at trigger
A breakpoint request occurs when Trace Buffer is full
Terminate tracing and generate breakpoint immediately on trigger
Terminate tracing immediately on trigger
6.4.7.2 Breakpoints Generated Via The TRIG Bit
If a TRIG triggers occur, the Final State is entered whereby tracing trigger alignment is defined by the
TALIGN bit. If a tracing session is selected by the TSOURCE bit, breakpoints are requested when the
tracing session has completed, thus if Begin aligned triggering is selected, the breakpoint is requested only
on completion of the subsequent trace (see Table 6-42). If no tracing session is selected, breakpoints are
requested immediately. TRIG breakpoints are possible with a single write to DBGC1, setting ARM and
TRIG simultaneously.
6.4.7.3 Breakpoint Priorities
If a TRIG trigger occurs after Begin aligned tracing has already started, then the TRIG no longer has an
effect. When the associated tracing session is complete, the breakpoint occurs. Similarly if a TRIG is
followed by a subsequent comparator channel match, it has no effect, since tracing has already started.
If a forced SWI breakpoint coincides with a BGND in user code with BDM enabled, then the BDM is
activated by the BGND and the breakpoint to SWI is suppressed.
6.4.7.3.1 DBG Breakpoint Priorities And BDM Interfacing
Breakpoint operation is dependent on the state of the BDM module. If the BDM module is active, the CPU
is executing out of BDM firmware, thus comparator matches and associated breakpoints are disabled. In
addition, while executing a BDM TRACE command, tagging into BDM is disabled. If BDM is not active,
the breakpoint gives priority to BDM requests over SWI requests if the breakpoint happens to coincide
with a SWI instruction in user code. On returning from BDM, the SWI from user code gets executed.
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
218
Freescale Semiconductor