MC9S12HY64 Datasheet, PDF (406/792 Pages) Freescale Semiconductor, Inc – S12 Microcontrollers

Pulse-Width Modulator (S12PWM8B8CV1)
Write: Anytime
11.3.2.15 PWM Shutdown Register (PWMSDN)
The PWMSDN register provides for the shutdown functionality of the PWM module in the emergency
cases. For proper operation, channel 7 must be driven to the active level for a minimum of two bus clocks.
Module Base + 0x0024
7
6
5
4
3
2
R
0
0
PWM7IN
PWMIF
PWMIE
PWMLVL
W
PWMRSTRT
Reset
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 11-17. PWM Shutdown Register (PWMSDN)
Read: Anytime
Write: Anytime
Table 11-9. PWMSDN Field Descriptions
1
PWM7INL
0
PWM7ENA
0
0
Field
Description
7
PWMIF
PWM Interrupt Flag — Any change from passive to asserted (active) state or from active to passive state will
be flagged by setting the PWMIF flag = 1. The flag is cleared by writing a logic 1 to it. Writing a 0 has no effect.
0 No change on PWM7IN input.
1 Change on PWM7IN input
6
PWMIE
PWM Interrupt Enable — If interrupt is enabled an interrupt to the CPU is asserted.
0 PWM interrupt is disabled.
1 PWM interrupt is enabled.
5
PWM Restart — The PWM can only be restarted if the PWM channel input 7 is de-asserted. After writing a logic
PWMRSTRT 1 to the PWMRSTRT bit (trigger event) the PWM channels start running after the corresponding counter passes
next “counter == 0” phase. Also, if the PWM7ENA bit is reset to 0, the PWM do not start before the counter
passes $00. The bit is always read as “0”.
4
PWMLVL
PWM Shutdown Output Level If active level as defined by the PWM7IN input, gets asserted all enabled PWM
channels are immediately driven to the level defined by PWMLVL.
0 PWM outputs are forced to 0
1 Outputs are forced to 1.
2
PWM Channel 7 Input Status — This reflects the current status of the PWM7 pin.
PWM7IN
1
PWM7INL
PWM Shutdown Active Input Level for Channel 7 — If the emergency shutdown feature is enabled
(PWM7ENA = 1), this bit determines the active level of the PWM7channel.
0 Active level is low
1 Active level is high
0
PWM7ENA
PWM Emergency Shutdown Enable — If this bit is logic 1, the pin associated with channel 7 is forced to input
and the emergency shutdown feature is enabled. All the other bits in this register are meaningful only if
PWM7ENA = 1.
0 PWM emergency feature disabled.
1 PWM emergency feature is enabled.
MC9S12HY/HA-Family Reference Manual, Rev. 1.04
406
Freescale Semiconductor