LM3S3748 Datasheet, PDF (276/753 Pages) List of Unclassifed Manufacturers – Microcontroller

General-Purpose Input/Outputs (GPIOs)
Register 16: GPIO Pull-Down Select (GPIOPDR), offset 0x514
The GPIOPDR register is the pull-down control register. When a bit is set to 1, it enables a weak
pull-down resistor on the corresponding GPIO signal. Setting a bit in GPIOPDR automatically clears
the corresponding bit in the GPIO Pull-Up Select (GPIOPUR) register (see page 275).
The commit control registers provide a layer of protection against accidental programming of critical
hardware peripherals. Writes to protected bits of the GPIO Alternate Function Select (GPIOAFSEL)
register (see page 269), GPIO Pull-Up Select (GPIOPUR) register (see page 275), and GPIO Digital
Enable (GPIODEN) register (see page 278) are not committed to storage unless the GPIO Lock
(GPIOLOCK) register (see page 280) has been unlocked and the appropriate bits of the GPIO
Commit (GPIOCR) register (see page 281) have been set to 1.
GPIO Pull-Down Select (GPIOPDR)
GPIO Port A (legacy) base: 0x4000.4000
GPIO Port A (high-speed) base: 0x4005.8000
GPIO Port B (legacy) base: 0x4000.5000
GPIO Port B (high-speed) base: 0x4005.9000
GPIO Port C (legacy) base: 0x4000.6000
GPIO Port C (high-speed) base: 0x4005.A000
GPIO Port D (legacy) base: 0x4000.7000
GPIO Port D (high-speed) base: 0x4005.B000
GPIO Port E (legacy) base: 0x4002.4000
GPIO Port E (high-speed) base: 0x4005.C000
GPIO Port F (legacy) base: 0x4002.5000
GPIO Port F (high-speed) base: 0x4005.D000
GPIO Port G (legacy) base: 0x4002.6000
GPIO Port G (high-speed) base: 0x4005.E000
GPIO Port H (legacy) base: 0x4002.7000
GPIO Port H (high-speed) base: 0x4005.F000
Offset 0x514
Type R/W, reset 0x0000.0000
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
reserved
Type RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
RO
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
reserved
PDE
Type RO
RO
RO
RO
RO
RO
RO
RO
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
Bit/Field
31:8
7:0
Name
reserved
PDE
Type
RO
R/W
Reset
0x00
0x00
Description
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
Pad Weak Pull-Down Enable
A write of 1 to GPIOPUR[n] clears the corresponding GPIOPDR[n]
enables. The change is effective on the second clock cycle after the
write.
276
April 08, 2008
Preliminary