PIC18F97J60_11 Datasheet, PDF (433/492 Pages) Microchip Technology – 64/80/100-Pin, High-Performance, 1-Mbit Flash Microcontrollers with Ethernet

PIC18F97J60 FAMILY
28.2 DC Characteristics: Power-Down and Supply Current
PIC18F97J60 Family (Industrial) (Continued)
PIC18F97J60 Family
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C  TA  +85°C for industrial
Param
No.
Device
Typ Max Units
Conditions
Note
Supply Current (IDD)^(2,3)
All devices 12.0 34.0 A
12.0 34.0 A
74.0 108.0 A
-40°C
+25°C
+85°C
VDD = 2.0V,
VDDCORE = 2.0V⁽⁴⁾
All devices 20.0 45.0 A
20.0 45.0 A
82.0 126.0 A
-40°C
+25°C
+85°C
VDD = 2.5V,
VDDCORE = 2.5V⁽⁴⁾
FOSC = 31 kHz
(RC_RUN mode,
Internal Oscillator Source)
All devices 105.0 168.0 A
-40°C
105.0 168.0 A
+25°C
VDD = 3.3V⁽⁵⁾
182.0 246.0 A
+85°C
All devices 8.0 32.0 A
8.0 32.0 A
62.0 98.0 A
-40°C
+25°C
+85°C
VDD = 2.0V,
VDDCORE = 2.0V⁽⁴⁾
All devices 12.0 35.0 A
12.0 35.0 A
70.0 95.0 A
-40°C
+25°C
+85°C
VDD = 2.5V,
VDDCORE = 2.5V⁽⁴⁾
FOSC = 31 kHz
(RC_IDLE mode,
Internal Oscillator Source)
All devices 90.0 152.0 A
-40°C
90.0 152.0 A
+25°C
VDD = 3.3V⁽⁵⁾
170.0 225.0 A
+85°C
1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to VDD or VSS, and all features that add delta
current disabled (such as WDT, Timer1 oscillator, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all IDD measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: Voltage regulator disabled (ENVREG = 0, tied to VSS).
5: Voltage regulator enabled (ENVREG = 1, tied to VDD).
6: For IETH, the specified current includes current sunk through TPOUT+ and TPOUT-. LEDA and LEDB are disabled for
all testing.
 2011 Microchip Technology Inc.
DS39762F-page 433