PIC18F97J60_11 Datasheet, PDF (184/492 Pages) Microchip Technology – 64/80/100-Pin, High-Performance, 1-Mbit Flash Microcontrollers with Ethernet

PIC18F97J60 FAMILY
15.1 Timer3 Operation
Timer3 can operate in one of three modes:
• Timer
• Synchronous Counter
• Asynchronous Counter
The operating mode is determined by the clock select
bit, TMR3CS (T3CON<1>). When TMR3CS is cleared
(= 0), Timer3 increments on every internal instruction
cycle (FOSC/4). When the bit is set, Timer3 increments
on every rising edge of the Timer1 external clock input
or the Timer1 oscillator, if enabled.
As with Timer1, the RC1/T1OSI and
RC0/T1OSO/T13CKI pins become inputs when the
Timer1 oscillator is enabled. This means the values of
TRISC<1:0> are ignored and the pins are read as ‘0’.
FIGURE 15-1:
TIMER3 BLOCK DIAGRAM
Timer1 Oscillator
Timer1 Clock Input
1
T1OSO/T13CKI
T1OSI
T1OSCEN⁽¹⁾
1
FOSC/4
Internal
0
Clock
TMR3CS
Prescaler
1, 2, 4, 8
2
Synchronize
Detect
0
Sleep Input
T3CKPS<1:0>
T3SYNC
TMR3ON
Timer3
On/Off
ECCPx Special Event Trigger
ECCPx Select from T3CON<6,3>
Clear TMR3
TMR3L
TMR3
High Byte
Set
TMR3IF
on Overflow
Note 1: When enable bit, T1OSCEN, is cleared, the inverter and feedback resistor are turned off to eliminate power drain.
FIGURE 15-2:
TIMER3 BLOCK DIAGRAM (16-BIT READ/WRITE MODE)
Timer1 Oscillator
T1OSO/T13CKI
T1OSI
T1OSCEN⁽¹⁾
T3CKPS<1:0>
T3SYNC
TMR3ON
FOSC/4
Internal
Clock
TMR3CS
ECCPx Special Event Trigger
ECCPx Select from T3CON<6,3>
Timer1 Clock Input
1
1
Prescaler
1, 2, 4, 8
0
2
Synchronize
Detect
0
Sleep Input
Timer3
On/Off
Clear TMR3
TMR3L
TMR3
High Byte
8
Set
TMR3IF
on Overflow
Read TMR1L
8
8
Write TMR1L
TMR3H
8
8
Internal Data Bus
Note 1: When enable bit, T1OSCEN, is cleared, the inverter and feedback resistor are turned off to eliminate power drain.
DS39762F-page 184
 2011 Microchip Technology Inc.