PIC18F97J60_11 Datasheet, PDF (360/492 Pages) Microchip Technology – 64/80/100-Pin, High-Performance, 1-Mbit Flash Microcontrollers with Ethernet

PIC18F97J60 FAMILY
TABLE 25-1: CONFIGURATION BITS AND DEVICE IDs
File Name
Bit 7 Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Default/
Unprogrammed
Value⁽¹⁾
300000h CONFIG1L DEBUG XINST STVREN —
—
—
—
WDTEN 110- ---1
300001h CONFIG1H —⁽²⁾
—⁽²⁾
—⁽²⁾
—⁽²⁾
—⁽³⁾
CP0
—
—
---- 01--
300002h CONFIG2L IESO FCMEN
—
—
—
FOSC2 FOSC1 FOSC0 11-- -111
300003h CONFIG2H —⁽²⁾
—⁽²⁾
—⁽²⁾
—⁽²⁾ WDTPS3 WDTPS2 WDTPS1 WDTPS0 ---- 1111
300004h CONFIG3L WAIT⁽⁴⁾ BW⁽⁴⁾ EMB1⁽⁴⁾ EMB0⁽⁴⁾ EASHFT⁽⁴⁾ —
—
—
1111 1---
300005h CONFIG3H —⁽²⁾
—⁽²⁾
—⁽²⁾
—⁽²⁾
—
ETHLED ECCPMX⁽⁵⁾ CCP2MX⁽⁵⁾ ---- -111
3FFFFEh DEVID1
DEV2 DEV1 DEV0 REV4
REV3
REV2
REV1
REV0 xxxx xxxx⁽⁶⁾
3FFFFFh DEVID2
DEV10 DEV9 DEV8 DEV7
DEV6
DEV5
DEV4
DEV3 xxxx xxxx⁽⁶⁾
Legend:
Note 1:
x = unknown, u = unchanged, - = unimplemented. Shaded cells are unimplemented, read as ‘0’.
Values reflect the unprogrammed state as received from the factory and following Power-on Resets. In all other Reset
states, the configuration bytes maintain their previously programmed states.
2: The value of these bits in program memory should always be ‘1’. This ensures that the location is executed as a NOP if it
is accidentally executed.
3: This bit should always be maintained as ‘0’.
4: Implemented in 100-pin devices only.
5: Implemented in 80-pin and 100-pin devices only.
6: See Register 25-7 and Register 25-8 for DEVID values. These registers are read-only and cannot be programmed by
the user.
DS39762F-page 360
 2011 Microchip Technology Inc.