PIC18F97J60_11 Datasheet, PDF (113/492 Pages) Microchip Technology – 64/80/100-Pin, High-Performance, 1-Mbit Flash Microcontrollers with Ethernet

PIC18F97J60 FAMILY
7.5.2 WRITE VERIFY
Depending on the application, good programming
practice may dictate that the value written to the
memory should be verified against the original value.
This should be used in applications where excessive
writes can stress bits near the specification limit.
7.5.3
UNEXPECTED TERMINATION OF
WRITE OPERATION
If a write is terminated by an unplanned event, such as
loss of power or an unexpected Reset, the memory
location just programmed should be verified and repro-
grammed if needed. If the write operation is interrupted
by a MCLR Reset, or a WDT Time-out Reset during
normal operation, the user can check the WRERR bit
and rewrite the location(s) as needed.
7.5.4
PROTECTION AGAINST
SPURIOUS WRITES
To protect against spurious writes to Flash program
memory, the write initiate sequence must also be
followed. See Section 25.0 “Special Features of the
CPU” for more details.
7.6 Flash Program Operation During
Code Protection
See Section 25.6 “Program Verification and Code
Protection” for details on code protection of Flash
program memory.
TABLE 7-2: REGISTERS ASSOCIATED WITH PROGRAM FLASH MEMORY
Name
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
TBLPTRU
—
—
bit 21 Program Memory Table Pointer Upper Byte
(TBLPTR<20:16>)
TBPLTRH Program Memory Table Pointer High Byte (TBLPTR<15:8>)
TBLPTRL Program Memory Table Pointer Low Byte (TBLPTR<7:0>)
TABLAT Program Memory Table Latch
INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE
RBIE TMR0IF INT0IF
RBIF
EECON2 EEPROM Control Register 2 (not a physical register)
EECON1
—
—
—
FREE WRERR WREN
WR
—
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used during Flash/EEPROM access.
Reset
Values
on Page:
69
69
69
69
69
71
71
 2011 Microchip Technology Inc.
DS39762F-page 113